Rear Spindle Nut: BSA Gold Star - Image 1
Rear Spindle Spacer: BSA Gold Star
Rear Spindle Spacer: BSA Gold Star £8.50
Back to products
Rear Brake Drum Bearing Sleeve : BSA Gold Star
Rear Brake Drum Bearing Sleeve : BSA Gold Star £36.00

Rear Spindle Nut: BSA Gold Star

£10.50

Rear Spindle Nut for Gold Star, B31, RGS and some A7 and A10 models with the “Crinkle Hub”

4 in stock

Compare
Add to wishlist
SKU: 67-6031 Categories: , Tags: ,
Description

Rear Spindle Nut for Gold Star, B31, RGS and some A7 and A10 models with the “Crinkle Hub”.

You may also like…

Sold out
Compare

BSA A7 & A10 Rear Spindle

,
£36.00

This rear spindle is for the later A7 & A10 with 8" full width hub.

Add to wishlist
Compare

Rear Spindle BSA Gold Star

,
£36.00

Rear Spindle for Gold Star, B31, RGS and some A7 and A10 models with the “Crinkle Hub”

Add to wishlist

    Related products

    Compare

    A65 Fork Top Nut Set

    ,
    £36.00

    These are nearly identical to the 65-5331 type, except that they are tapped 5/16"-26 for the fitting of damper rods for double damping. This means that they will actually fit a very wide variety of different BSA models.  Sold as 2-off.

    Add to wishlist
    Compare

    BSA A7 & A10 Front Spindle Nut Ariel Hub

    ,
    £8.50

    This front spindle nut is for the A7 & A10 bikes that were produced circa 1958 with Ariel type full width hubs.

    3/4"-20TPI

    Add to wishlist
    Compare

    BSA A7 & A10 Front Spindle Ariel Full Width Hub

    ,
    £34.00

    This spindle is for the A7 & A10 bikes that were produced in the late 1950's with Ariel type full width hubs.

    Add to wishlist
    Compare

    BSA and Triumph Fork Top Nut Washers

    ,
    £5.00

    These washers (2-off) fit the two main types of fork top nuts in the BSA range, and may also be found useful if washers are needed under most of the Triumph fork top nuts of the period. The internal diameter of the washer is 1.067".

    Add to wishlist
    Compare

    BSA Handlebar Clamp Spacer

    ,
    £4.80

    These spacers (2-off) are used with the long clamp screw used on models which incorporate a steering damper.  Two short + two of these longer screws are required. They fit under the Damper Knob Securing Plate.

    Add to wishlist
    Compare

    BSA Handlebar Clamps for BSA “A ” and “B” Models

    ,
    £34.00

    A high quality reproduction set of 2 handlebar clamps suitable for virtually all BSA's, from the '40's to the early '70's, fitted to models from 250cc and upwards.

    Add to wishlist
    Compare

    Steering Damper Centre: BSA “A” & “B” Series Models

    ,
    £8.50

    This is part of the steering damper assembly, fitted under the lower steering yoke.  The damper rod, if fitted, screws into it.

    Add to wishlist
    Compare

    Steering Damper Knob Securing Plate-BSA

    ,
    £15.00

    This secures the adjuster knob in place after adjustment.

    Add to wishlist